By Hailie Stevens |

Fellow's Take on Kenya Kapsokisio by Tim Wendelboe | Brew Recipe

Tim Wendelboe has been buying coffee from the Kapsokisio cooperative since 2012, and, after falling in love with their coffees, raised money to help them build new drying beds. 90% of this lot consists of the unique K7 variety, which gives it a distinctly crisp and fruity flavor. We tasted rose hip, hibiscus, and red berries.

🌍 Origin: Mt. Elgon, Kenya

💦 Process: Washed

🔬 Variety: K7, SL28, Sl34

⛰️ Elevation: 1,800 - 2,000 MASL

🔥 Roast: Light

⚖️ Bag Size: 250 g (8.8 oz)

Brew Recipe for Tim Wendelboe Kenya Kapsokisio

Using Stagg X Dripper

Ingredients:

19.5g of Kenya Kapsokisio

300g of water

208°F

Steps

1. Measure and grind coffee at a medium-coarse setting

Measure out 19.5g of coffee beans and grind them on a medium setting. We used setting 5.1 - 6.1 on Ode with SSP Burr / 4.1 - 5.1 on Ode with Gen 2 Burrs, which is about 3.1 - 4.1 on Ode with Gen 1 Burrs. Suggested setting on Opus is between 6 and 7- and note that the inner ring was set to 0 at 5 for us!

We suggest grinding toward the finer end of the ranges above if the coffee has been resting 10 days or more (i.e. if the coffee is 10 or more days off of roast). 

  1. Heat water and rinse the filter

Heat water to 208°F and rinse your filter before putting your coffee grounds in, making sure to dispose of the rinse water prior to brewing.

3. Pour around 48.5g water for the bloom 

Fully saturate your coffee grounds with around 48.5g of water, and allow 40-45 seconds for the bloom.

4. Continue pouring in four stages

After the bloom, pour to 150g; then when the water is approximately 0.5 in above the bed of grounds, pour to 250g; once water drains halfway, pour to 300g. The total brew time varies, but we’re aiming for between 2:00 - 2:30 minutes.

5. Decant into your favorite mug and enjoy!

Look out for the incredible flavors of rose hip, hibiscus, and red berries.

Espresso

Ingredients:

20g of the same coffee

40g of water at 201°F

1:2 ratio

28-32 second pull time

Steps

1. Measure and grind coffee

Measure out 20g of coffee beans.

2. Make sure your espresso machine is at temp.

Water should ideally be at  201°F.

4. Grind your coffee

We suggest a brew time of 28-32 seconds.

4. Pull shot at 9 bars!

Pull your shot at 9 bars with around a 28-32 second pull time.

5. Decant into your favorite demitasse cup and enjoy!

Let us know what flavors pop out in your espresso. We suggest stirring with a small spoon before tasting to integrate all layers of the ‘spro

Aiden

Single serve:

1:15.5 ratio

1:1.5 bloom ratio

208°F bloom temp

0:40 - 0:45s bloom time

208°F pulse temps

0:40 sec between pulses

2 pulses

Batch:

1:15.5 ratio

1:1.5 bloom ratio

208°F bloom temp

0:40 - 0:45s bloom time

208°F pulse temps

0:40 sec between pulses

3 pulses

Steps

1. Measure and grind coffee

Measure out the weight of beans (dry dose) that Aiden recommends once you enter in the amount of water volume you want out. For single serve at 150ml out, grind around 4 on Ode + SSP, 3 Ode Gen 2 - a medium-fine grind setting. We ground at this setting when using 9.6g of coffee in to 150ml of total liquid out. Grind setting will need to be incrementally coarser as the amount of coffee increases.

For batch, we’d recommend grinding around 9 on Ode + SSP, which is 10 on Ode Gen 2 - a coarse setting. We used a setting 10 on Ode Gen 2 with 97g of coffee in to 1500ml of liquid out. Grind setting will need to be incrementally finer if using less coffee.

2. Make sure your Aiden is programmed to the parameters above.

You can enter in your own custom Brew Profile in the “Edit Profiles” menu! You can edit single serve and batch settings under “advanced” at the bottom of the profile editor screen.

4. Rinse your filter

We suggest rinsing your paper filter in the Aiden basket prior to brewing (and if you rinse when the basket is in your Aiden machine, be sure to dump out the excess water from the carafe!)

4. Start your brew!

Once you have your Brew Profile setup in the “Edit Profiles” menu, go back to the main menu, and into “Guided Brew”. You should see your custom Brew Profile if you scroll down!

5. Wait for the chime, swirl, and pour!

Aiden will chime when the coffee is ready to go! Simply swirl your carafe to get all of the good stuff in the coffee mixed evenly, and pour!